Strip of 3 8 inch of insulation from the ends. Unscrew and remove the switch plate.

How To Install Dimmer Switches Home Electrical Wiring Diy

Using your needle nose pliers bend the wire back onto the clip and pinch it down tightly so there s no interference with the dimmer switch.

How to replace a light switch with a dimmer. To replace a standard switch with a dimmer switch follow these steps. If the house wires are bent use a wire stripper to cut off the twisted ends. Twist the ends together clockwise and cap them using a wire connector nut.

It doesn t matter if you reverse the two switch wires to a single pole dimmer. Once the switch is secured take the faceplate and place it over the switch. Autoplay when autoplay is enabled a suggested video will automatically play next.

Next using a pair of needle nose pliers wrap the bare ground wire around the green screw at the bottom of the new standard switch. Loosen the screw that holds the grounding wire to the switch and remove the dimmer switch from the switch box. Connect the ground wire from your dimmer to a green or bare copper wire in the wall box.

Use your wire cutters to cut off the ends of the wire. Fold the wires neatly into the box. Turn off the power to the switch at the circuit or fuse panel.

Screw the dimmer to the box with the screws provided. First of all read all the instructions before you tackle any project. In this video i show you how to replace a rocker type light switch with a dimmer switch.

You can replace the dimmer switch with a regular light switch only from what you have described you need to install a 3 way light switch not a single pole light switch. Replacing a light switch can seem intimidating but if you follow the right steps it can be done in just a few minutes. Place the dimmer switch completely into the junction box and use the two included screws to secure the switch to the box.

I purchased a single pole boring light switch to replace a not really used dimmer and i want to be cautious and check myself. I apologize if this is a duh question. Finish the job by installing the cover plate and turning on the power to test the new dimmer.

Remove 3 4 inch of casing from the end of the house wires and the dimmer switch wires if needed. Then use a voltage tester to make sure that the circuit is dead. The guides all show switches t.

Disconnect the traveler and or common wires from the dimmer switch. Use your flat head screwdriver and screw the faceplate in with the two included screws. Strip the ends of the wire.

The black wire to the lone screw on the 3 way light switch. The typical connections are as follows. The dimmer switch is now installed and ready to go.

Unscrew the switch from the electrical box and pull it out with.